What Are Pull Out Tray Support Bars?
Pull out tray support bars are replacement components designed for kennels that use a pull-out tray system. Their job is to hold the tray in place while still allowing it to slide out for cleaning. Over time, original bars may bend or wear, making the tray unstable or hard to remove. Replacing them restores proper function.
The pull out tray support bars from thetopdogpetstore are specifically made to fit 43 inch kennels. Before you begin installation, confirm your kennel's interior width matches this size.
Product Facts: Pull Out Tray Support Bars
- Pull out tray support Bars: Pull out tray support Bars are replacement support bars designed for pull-out tray setups in kennels. According to the available product information, they fit 43 inch kennels. Knowing the exact fit (43 inch kennels) prevents ordering the wrong size. Measure your kennel's interior width to confirm compatibility before purchase.
Pull out tray support Bars - Pull out tray support Bars: Available SKU: Standard (SKU-83302e73900e). Brand: thetopdogpetstore. Use the SKU when ordering to ensure you receive the correct standard version intended for pull-out tray support.
How to Install Pull Out Tray Support Bars
The following steps are based on general installation practices for pull-out tray support bars in kennels. The supplied product information does not include specific manufacturer instructions, so use these as a general guide and always check your kennel's manual if available.
- 1. Remove the old support bars: Slide the tray out fully. Locate the existing support bars—typically one on each side of the kennel frame. Unscrew or unclip them. If they are riveted, you may need a drill or rivet removal tool. Keep any hardware that is still in good condition.
- 2. Position the new bars: Align each replacement bar so it sits flush against the kennel side, at the same height as the original. The bar should run parallel to the tray's edge, supporting it without obstructing the slide-out path.
- 3. Secure the bars: Use the original screws, clips, or rivets to attach the new bars. If the supplied hardware is different, match thread size and length to avoid damaging the kennel frame. Tighten evenly on both sides.
- 4. Test the tray movement: Insert the tray and slide it in and out several times. The tray should move smoothly without catching and should rest level on the bars. If it wobbles or sticks, adjust the bar position slightly.
Compatibility Check Before You Buy
The pull out tray support bars are confirmed to fit 43 inch kennels. However, not all 43 inch kennels use the same mounting system. Check whether your kennel uses screws, clips, or rivets to hold the support bars. Also verify the thickness of the kennel frame—bars designed for thin wire frames may not fit thicker plastic or wood frames.
If your kennel is a different size or uses a non-standard tray support system, these bars may not be compatible. Measure carefully and compare with the product dimensions if listed.
